Epson ColorPage EPL-C8000 Service Manual page 341

EPSON EPL-C8000
Table 5-12. Error Message List (7/9)
o Print Overrun
LED status 1/2. On Line = off, Continue = blinking
Explanation The print data is too complicated and the printer cannot process
the data quickly enough
Solution 1. If the Auto Cont setting on the printer's Device menu is
disabled, select and follow one of the solutions below.
l
Press the Continue button and if there is enough
memory, the printer will attempt to print one more time,
which may bring up the same error. However if there is
not enough memory or if the Print Overrun error recurs,
the data for that page will be lost and the printer will
begin processing the next page of data.
l
Reset the printer or perform a warm boot.
2. If the Auto Cont setting on the printer's Device menu is
enabled, the printer will automatically override the error and
undergo the same process as described above.
o Mem Overflow
LED status 1/2. On Line = off, Continue = blinking
Explanation While processing a print job, the printer ran out of memory.
Recovery/continuation is not possible.
Solution 1. If the Auto Cont setting on the printer's Device menu is
disabled, select and follow one of the solutions below.
lPress the Continue button and if the error was caused
because graphic data exceeded buffer size, the printer ignores
the command which caused the error ejects the page before
the error. On the other hand, the cause of the error was a
failure in registering the font macro pattern or so, the printer
ignores the bad command and continues to print.
lReset the printer or perform a warm boot.
2. If the Auto Cont setting on the printer's Device menu is
enabled, the printer will automatically override the paper error
and undergoes the same process depending on the cause, as
described above.
Chapter 5 TROUBLESHOOTING
Table 5-13. Error Message List (8/9)
o Illegal Aux I/F Card
LED status On Line = off, Continue = off
Explanation An incompatible optional interface card has been installed.
Solution Turn off the printer and remove the incompatible card.
o Illegal DIMM g
LED status On Line = off, Continue = off
Explanation An illegal ROM module has been installed to the slot g (g=A/B).
Illegal DIMM for this error is defined as a ROM module that can
not be written in and not formatted, or crashed ROM. If the printer
can not write on the ROM because it is not formatted, the
message "Format Error DIMM g" is indicated instead.
Solution Turn off the printer and remove the ROM module.
o Write Error DIMM A
LED status On Line = off, Continue = off
Explanation Attempted to write to ROM module or write operation failed to
terminate normally; ROM module is not set in the slot A.
1. Turn off the printer.
Solution
2. Perform a Reset All operation.
o Write Error DIMM P
LED status On Line = off, Continue = off
Explanation Attempted to write to ROM module; write operation failed to
terminate normally; data reception failed; there was an error in the
checksum for the received data; failed to secure receive-data
area; or specified device value was improper.
Turn off the printer.
Solution 1.
Perform a Reset All operation.
2.
If error recurs, service the printer.
3.
Rev. B
5-7