EPSON EPL-C8000
FIP-1.33 TONER CARTRIDGE Y/M/C/K is Out
Step
Check point
Perform the preliminary inspection.
1
Parts to inspect:
Toner Cartridge, CARTRIDGE SENSOR, MCU PWB
Check: Sticker on a Toner Cartridge
l
2
Is a white reflective sticker attached to the relevant
Toner Cartridge?
Check: CARTRIDGE SENSOR installation
3
l
Is the CARTRIDGE SENSOR properly installed?
Check: Toner Cartridge replacement
4
Replace the relevant Toner Cartridge with a new one.
l
Does the problem still occur?
Check: CARTRIDGE SENSOR
l
Is the CARTRIDGE SENSOR properly functioning?
5
Diag Tool: Digital Input Test
Device code: 0D
FIP-1.34 PCDC Error
Step
Check point
Perform the preliminary inspection.
1
Parts to inspect: MCU PWB
Isolation: Engine or Controller?
Run the Engine test print or diagnostic test print.
2
(10 sheets for each of single and continuous print)
l
Are the outputs normal?
Check: MCU PWB replacement
3
Replace the MCU PWB.
l
Does the problem still occur?
Chapter 5
TROUBLESHOOTING
Remedy
Yes
Replace/reinstall the defective part(s).
Go to Step 3.
Go to Step 4.
• With the diagnostic tool, go to step 5.
• Without the diagnostic tool, go to
FIP-2.22 "CARTRIDGE SENSOR is
Defective".
Replace the MCU PWB.
Remedy
Yes
Replace/reinstall the defective part(s).
Check the Controller PWB.
If the problem still occurs, go to step 3.
Go to FIP-2.39 "Electrical Noise".
No
Go to Step 2.
Replace the relevant Toner Cartridge.
Install the CARTRIDGE SENSOR
properly.
Problem solved.
Go to FIP-2.22 "CARTRIDGE SENSOR
is Defective".
No
Go to Step 2.
Go to Step 3.
Problem solved.
Rev. B
5-49