Epson ColorPage EPL-C8000 Service Manual page 56

EPSON EPL-C8000
Any of the events 1 to 5 listed below terminates power-save
standby (if it is currently active), resets the timer, and restarts
the countdown. If the countdown proceeds to 1/2 the standby
time setting, the printer switches into power-save level 1. If the
countdown then reaches the full standby time setting, the printer
switches into power-save level 2.
Events
(1) Generation of first printable image is completed,
following entry into emulation mode.
(2) Request to print.
(3) Reset from control panel.
(4) Warm boot.
(5) Standby set to Disable (at panel or by EJL).
l Standby Level 1
Uses less power than "normal'' standby mode, by maintaining
the fuser unit temperature within a lower range. Power saving is
not as great as at level 2 (note that level 1 is not EnergyStar-
compliant, since power usage is above 45W), but the warm-up
time required to move back into normal standby mode is
relatively short (about 60 seconds).
l Standby Levd 2
Provides greater power savings than standby level-1 mode, by
switching off the fuser unit and many of the mechanical circuits.
Level 2 is EnergyStar compliant (not above 45W), but warm-up
time required to return to normal standby mode is relatively long
(about 300 seconds).
Chapter 1 PRODUCT DESCRIPTIONS
2. Page Count
Displays total number of pages printed to date (display only).
Counting stops at 99999999. On this printer, the count is
obtained from the engine.
Display range: 0 to 99999999
(advances by 1 with each sheet printed)
3. SelecType lnit
Returns panel settings to their factory defaults. The following
counters are not reset: Page counter, YMCK Toner counters,
2nd BTR counter, lBT Cleaner counter, Fuser-Unit counter,
Engine Printer 1 counter, Engine Printer 2 counter.
Rev. B
1-40