Epson ColorPage EPL-C8000 Service Manual page 340

EPSON EPL-C8000
Table 5-10. Error Message List (5/9)
o Replace Waste T Box
LED status On Line = off, Continue = off
Explanation The engine has detected that the Waste Toner Collector is full.
Printing stopped.
Solution Open the front cover, replace the Waste Toner Collector with a
new one, and close the cover to clear the error.
o Replace Oil Roll
LED status On Line = off, Continue = off
Explanation Engine detected that fuser oil has run out. Print stopped.
Solution Open the fuser unit, replace the Fuser Oil Roll with a new one,
and close the cover to clear the error.
o Turn Paper
LED status On Line = off, Continue = off
Explanation The paper is loaded with the shorter edge first.
Solution Rotate the paper to load it with the longer edge first.
o Manual Feed s s s t t t t
LED status On Line = off, Continue = off
Explanation When "Manual Feed" is enabled by the command or panel
operation, print is requested.
Solution 1. Set paper in the indicated paper source and press the Continue
or On Line button, and the printer prints on a page and
indicates the same error when loading paper for the next page.
When copy was selected, result varies depending on the button
pressed, Continue or On Line. If the button pressed was
Continue, the error does not occur during copying, except for
the case paper has run out. On the other hand, if the On Line
button was used, the error message appears after each page
including copied page. "Check Paper Size" error does not
occur if "Size Ignore" in config menu is disabled.
2. Press the Continue button or On Line button without setting any
paper in the indicated paper source. Paper is loaded from the
available paper source with the highest priority. If neither of the
paper sources has paper in it, the same error occurs. (This
circumstance does not generate "Paper Out" error. Other
actions affect same as described in Solution 1.
3. Perform Reset or Warm boot.
Chapter 5 TROUBLESHOOTING
Table 5-11. Error Message List (6/9)
o Paper Out s s s s s t t t t
LED status On Line = off, Continue = off
There is no paper loaded in the selected paper source
Explanation 1.
s s s s s.
2. Paper is set in none of the paper sources. (In this case,
the paper source previously used is indicated. If this
condition is detected at power on, however, "LC1" is
indicated.)
"t t t t" shows the paper size selected.
Solution 1. Load the correct size of paper t t t t in the appropriate paper
source s s s s s to clear the error.
2. Load the correct size of paper in any of the paper sources to
clear the error.
o Paper Set s s s s s t t t t
LED status 1/2. On Line = off, Continue = blinking
Explanation When the Size Ignore setting on the printer's Device menu is set
to Off, if the paper loaded in the selected paper source s s s s s
does not match the selected paper size t t t t.
Solution 1. If the Auto Cont setting on the printer's Device menu is
disabled, select and follow one of the solutions below.
lSet the paper of size t t t t in the paper source s s s s s and
press the Continue button. The error clears and the printer
resumes printing on the paper from the paper source s s s s s.
l
Press the Continue button, without changing the paper
or paper source, to clear the error and print on paper
from the paper source s s s s s.
l
Reset the printer or perform a warm boot.
2. If the Auto Cont setting on the printer's Device menu is
enabled, the printer will automatically override the paper
mismatch error and print on paper from the paper source s s s
s s.
Rev. B
5-6