Epson ColorPage EPL-C8000 Service Manual page 266

EPSON EPL-C8000
NOTE: In the following step, do not touch the tracking roll surface with
your hands. If you touch the roll surface or find oil on it, wipe the
tracking roll surface well using a clean cloth to remove oil
completely.
4. Using a clean cloth, clean the tracking roll (white) located in front of
the Developer Assy (in front of the Magnet Roll).
NOTE: In the following step, be sure to make a mark on the tracking roll.
Based on the mark, you will see how much the tracking roll
moves.
5. Make a mark on the tracking roll.
NOTE: Action in the next step is to prevent the tracking roll from
touching the earth plate. Neglecting this operation will cause the
earth plate to interfere with tracking roll's movement.
6. Note the magnet Roll in the Developer Assembly and the tracking
roll move back and forth a little. To remove play, push the Magnet
Roll to the rear end. Then push the tracking roll to put it in contact
with the ball bearing behind.
Chapter 3 Disassembly and Assembly/Adjustment
6)-1
5)
6)-2
Tracking Roll
Figure 3-151. Tracking Roll
Revision B
3-124