Regi. Metal Roll Removal (Pl5.2.16) - Epson ColorPage EPL-C8000 Service Manual

EPSON EPL-C8000

3.2.8.9 REGI. METAL ROLL Removal (PL5.2.16)

1. Remove the MSI TRAY ASSEMBLY. (See Section 3.2.7.1.)
2. Remove the MSI ASSEMBLY. (See Section 3.2.7.2.)
3. Remove the MAIN P/H ASSEMBLY. (See Section 3.2.8.1.)
4. Remove the REGI. CLUTCH. (See Section 3.2.8.7.)
5. Using the standard driver or equivalent, remove the REGI UPPER
BEARING at the back of the REGI. METAL ROLL.
6. Remove the REGI. BRAKE ASSEMBLY. (Refer to Section 3.2.8.8.)
7. Remove the E-ring fixing the REGI. OUT GEAR and remove the
REGI. OUT GEAR.
8. Using a standard driver or equivalent, remove the REGI. UPPER
BEARING in front of the REGI. METAL ROLL.
9. Open the REGI. CHUTE ASSEMBLY.
10. Lift up the rear part of the REGI. METAL ROLL and shift it to the
rear. Then remove the REGI. METAL ROLL.
Chapter 3 Disassembly and Assembly/Adjustment
Figure 3-53. REGI. METAL ROLL Removal
When installing the REGI. METAL ROLL the side whose
end with shorter diameter is longer than the other must
come to the front.
Revision B
3-47