EPSON EPL-C8000
3.2.16.9 ENVIRONMENT SENSOR Removal (PL13.2.5)
1. Remove the MSI TRAY ASSEMBLY. (See Section 3.2.7.1.)
2. Remove the MAIN P/H ASSEMBLY along with the MSI
ASSEMBLY. (See Section 3.2.8.1.)
3. Disconnect the connector (P/J105) for the ENVIRONMENT
SENSOR and release the harness from the clamp.
NOTE: In the following steps, never touch the IBT BELT
ASSEMBLY.
4. Remove the screw (silver, cup head, 8mm) securing the
ENVIRONMENT SENSOR and remove the ENVIRONMENT
SENSOR.
When fastening the screw, install the earth wire
together.
Chapter 3
Disassembly and Assembly/Adjustment
Figure 3-144. ENVIRONMENT SENSOR Removal
Revision B
3-118