Printer Message Details Of Status Messages And Remedies; Details Of Error Messages And Remedies - Epson AcuLaser Color 2000 Service Manual

EPSON AcuLaser C2000
3.2.1 Printer Message Details of Status Messages
and Remedies
Below are the status messages that are unique to this printer.
Calibrating Printer
Explanation
This is one READY message. At the following timing, engine is
automatically calibrated.
1. At powering on
2. Cover is opened and closed except for canceling Jam error.
3. It has printed 100 pages or 24 hours passed from the last
calibrating and returned from Standby state.
LED
The Continue LED is off. LED blinks.
Treatment Method
Wait for about one minute and the printer will automatically
resume. Do not open any printer cover while calibrating.
Cooling Down
Now cooling down the printer engine.
Explanation
At the following timing, cooling operation is automatically started.
When starts print to OHP sheets, if the internal temperature is too
high.
LED
The Continue LED is off. LED blinks.
Treatment Method
Wait for about one minute and the printer will automatically
resume and start printing.
Troubleshooting

3.2.2 Details of Error Messages and Remedies

Below are the error messages that are unique to this printer.
Check Media Type
Explanation
A paper which is not correct OHP sheet is fed. Or printed on OHP
sheets although OHP has not been selected.
Does not print and eject the sheet. When duplex is selected, sheet
remains in the Duplex unit and paper jam occurs.
LED
The On Line LED is off and Continue LED is on.
Treatment Method
1) Set correct sheet to the paper feeder.
Press the Continue switch to release the error.
2) Execute Reset or Warmboot.
Install Photocondctr
Explanation
The Photoconductor Unit is not set. Or it is not set correctly.
LED
The On Line LED and Continue LED are off.
Treatment Method
Open the Front cover. Remove the Waste Toner Collector if it is
set then reinstall the Photoconductor unit correctly. Reset the
Waste Toner Collector then close the Front cover, and the error
will released automatically.
Install Waste T Box
Explanation
A Waste Toner Collector is not set. Or it is not set correctly.
LED
The On Line LED and Continue LED are off.
Treatment Method
Open the Front cover, set a Waste Toner Collector, then close the
cover. The error will be canceled automatically.
Install Oil Roll
Printer Message
Revision C
101