Fip-1.41 Sd-Ram (Slot S0, S1, S2) Related Error; Fip-1.42 Controller Pwb Ic8, Ic9 Related Error - Epson ColorPage EPL-C8000 Service Manual

EPSON EPL-C8000

FIP-1.41 SD-RAM (SLOT S0, S1, S2) Related Error

Step Check point
Perform the preliminary inspection below:
• Remove all optional electrical unit modules to return the
1
printer to the standard condition.
• Check that all connectors are properly connected to the
CONTROLLER PWB.
Check: SD-RAM
1. Remove all SD-RAMs from the RAM slots 0, 1, and 2.
2. Check that the printer is turned off.
3. Install a SD-RAM to slot 1 and turn the printer on.
4. Repeat the steps 2 and 3 to add other SD RAMs one by
one to the slot 1 and 2.
l
2
Is there any defective SD-RAM?
NOTE:
• Be sure to install a SD-RAM whose memory is more
than 32MB in the slot 0.
• Before reinstalling each SD-RAM, verify the correct
direction for installing it; and insert it to the socket until it
is locked.

FIP-1.42 CONTROLLER PWB IC8, IC9 Related Error

Step Check point
Perform the preliminary inspection below:
• Remove all electrical unit modules to return the printer
1 to the standard condition.
• Check that all connectors are properly connected to the
CONTROLLER PWB.
Check: Defective IC
Replace the IC according to the error type as follows:
- Error C1100: Replace the IC9.
2
- Error C1101: Replace IC8.
- Other error code: replace the CONTROLLER PWB.
l
Does the problem still occur?
Chapter 5 TROUBLESHOOTING
Remedy
Yes
Replace/reinstall the defective part(s).
Replace/reinstall the defective part.
Remedy
Yes
Replace/reinstall the defective part(s).
Replace/reinstall the defective part.
No
Go to Step 2.
Problem solved.
No
Go to Step 2.
Problem solved.
Rev. B
5-55