Specifying Basic Software Settings - Brother PE-Design Next Instruction Manual

Specifying Basic Software Settings

Adjusting on-screen
measurements
(Screen Calibration)
Measurements can be adjusted so that objects will
be displayed at the same size as the actual
embroidery at a zoom ratio of 100%. Once this
adjustment is made, it will not need to be done again
later.
1.
Click 1, then 2.
1
2.
Click Screen Calibration (1). Hold a ruler
against the screen to measure the length of 2.
Next, enter the value at 3, and then click OK
(4).
1
3
2
Be sure to enter the length in millimeters. A
value in inches is invalid.
22
Understanding Windows
2
4
System unit
1.
Click System Unit, and then select the
desired measurement units (mm or inch).