Brother PE-Design Next Instruction Manual page 277

DST Import Setting
If the number of consecutive jumps in the DST
file is less than the number of jumps specified
here, those consecutive jumps will be
replaced with a stitch.
If the number of consecutive jumps in the DST
file is greater than or equal to the number of
jumps specified here, those jumps will be
replaced with a jump stitch where the thread is
trimmed.
DST Export Setting
When .pes files are output, jump stitches with
thread trimming are replaced with more
consecutive jump codes than the specified
number of jumps.
Adding jump stitch trimming
to new patterns
When creating a new embroidery pattern for our
multi-needle embroidery machines, you can specify
whether or not to add jump stitch trimming to the
pattern.
a
Note:
These settings are applied only when
embroidering with our multi-needle
embroidery machines. Before these settings
can be specified, select
Machine Type in the Design Settings
dialog box.
Click Jump Stitch Trimming (1), and then select
the Add jump stitch trimming to the entered
patterns. check box (2). And then click OK (3).
1
2
3
Changing the Appearance of the Application (Options)
under
If the check box was selected, a new
embroidery pattern that is created appears
as shown below.
If the check box was cleared, a new
embroidery pattern that is created appears
as shown below.
275