Editing A Pattern In Fill/Stamp Mode - Brother PE-Design Next Instruction Manual

Editing a Pattern in Fill/Stamp Mode

■
Selecting patterns
1.
To use the Select tool, click 1, then 2.
1
2
2.
Click the pattern.
.
3.
To select an additional pattern, hold down the
key and click the other pattern.
Ctrl
b
Memo:
• You can also select patterns by dragging
the pointer across the pattern.
• Hold down the
Ctrl
selected pattern to deselect it.
■
Moving patterns
Selected patterns can be dragged to move them.
b
Memo:
• To move the pattern horizontally or
vertically, hold down the
dragging it.
• Pressing the arrow keys moves the
selected pattern one grid mark in the
direction of the arrow on the key.
Rotation
handle
Handles
key and click a
key while
Shift
Editing a Pattern in Fill/Stamp Mode
■
Scaling patterns
Drag a handle of the selected pattern to adjust its
size. Drag the rotation handle to rotate the pattern.
b
Memo:
• If the key is held down while a handle
Shift
is dragged, the pattern is enlarged or
reduced from the center of the pattern.
• To flip the selected pattern(s) up/down, or to
flip the selected pattern(s) left/right, click 1,
then 2.
1
2
• Using commands other than those
mentioned above, selected patterns can be
edited in other ways, for example,
duplicated or deleted.
c
"Menus/Tools" of "Programmable
Stitch Creator" on page 289.
■
Reshaping a fill/stamp stitch
patterns
1.
Click 1, then 2.
1
2
2.
Click the broken line.
235