Brother PE-Design Next Instruction Manual page 164

Tutorial 10-2: Creating Design for Multi-Position Hoops
b
Memo:
• Settings for multi-position hoops are
indicated by " ".
• Choose the appropriate setting after
checking the size of the hoop available for
your machine.
Step 2 Creating the design
1
The Design Page appears on the screen as
shown below.
b
Memo:
• Area a: Embroidering area when the multi-
position hoop is installed at the top
installation position.
• Area b: Embroidering area when the multi-
position hoop is installed at the middle
installation position.
• Area c: Embroidering area when the multi-
position hoop is installed at the bottom
installation position.
The dotted lines separate each area.
2
Create the design, making sure that it meets
the following conditions.
162
a
b
c
a
b
c
• The size of one pattern must be no larger
than 100  100 mm (or 130  180 mm).
• Each pattern must completely fit within a
single area (a, b, or c).
b
Memo:
1
3
2
1: The position of this pattern is correct since
it fits completely within area a.
2: The position of this pattern is correct since it
fits completely within either area b or area c.
3: The size of this pattern is acceptable, but
its position must be corrected since it does
not fit completely within any of the areas.
(It will be necessary to correct the position
in order to fit in either b or c.)
4: This pattern must be corrected since it is
too large.
(It will be necessary to correct the position
and size in order to fit in either a, b, or c.)
a
b
4
c