Brother PE-Design Next Instruction Manual page 159

a
Note:
• For best results, attach the stabilizer to the
fabric (as described on this page). Without
the correct stabilizer, the design may
become misaligned due to puckering in
the fabric.
• Be sure to check the recommendations on
the stabilizer package.
Step 5 Using the Positioning Sheet,
mark the embroidering
position on the fabric
b
Memo:
• The Positioning Sheets are included in the
package.
• The Positioning Sheets are also in the
Positioning Sheet folder and can be
printed out with a printer.
• Location of the Positioning Sheets:
C:\Program Files (Program Files (x86))\
Brother\PE-DESIGN NEXT\Positioning
Sheet.
• The positioning sheets in the PDF files are
at actual size. When printing the positioning
sheet from the PDF file, be sure to print it at
actual size. Do not print while reducing or
enlarging to fit the paper size.
1
Punch a hole at the end of each arrow on the
Positioning Sheet.
2
Place the Positioning Sheet on the fabric, and
then insert the tip of a marking pen into each
hole to mark the fabric.
Tutorial 10-1: Creating Split Embroidery Designs
3
Connect the points marked on the fabric to
draw reference lines.
4
Place the Positioning Sheet on the fabric, and
mark points A, B, C and D.
5
To mark an area to the right of the previously
marked area, align points A and D on the
Positioning Sheet with marks B and C on the
fabric.
6
To mark an area below the previously marked
area, align points A and B on the Positioning
Sheet with marks C and D on the fabric.
A B
D C
A A B B
D D C C
A B
A B
D C
D C
157