Jump Stitch And Jump Stitch Trimming - Brother PE-Design Next Instruction Manual

Jump Stitch and Jump Stitch Trimming

Jump Stitch and Jump Stitch Trimming
Machine thread trimming according to settings specified in Layout & Editing
If the multi-needle embroidery machine is selected in the Design Settings dialog box of Layout & Editing,
trimming can be turned on or off at each jump stitch location.
These settings are saved in embroidery data files (.pes).
If you are using our multi-needle embroidery machine with the Jump Stitch Trimming function turned on to
embroider this imported .pes file, the machine will trim the thread according to the PES data settings.
a
Note:
For details on the jump stitch trimming function of the machine, refer to the Operation Manual provided with your
embroidery machine.
■
Specifying trimming settings in Layout & Editing
1.
Select the multi-needle embroidery machine in the Design Settings dialog box.
c
"Specifying the Design Page Size and Color" on page 85
2.
Display the trimming locations in Layout & Editing.
c
Memo of "Changing the display of the embroidery design" on page 70
3.
Turn on/off jump stitch trimming for each embroidery pattern.
c
"Jump Stitch Trimming" on page 75
If necessary, change settings for the following.
• Automatically turning off trimming when the jump stitch length is less than that specified.
c
"Jump Stitch Trimming" on page 75 and "About Minimum jump stitch length for thread trimming" on
page 75
• Default setting for turning on/off jump stitch trimming when a new embroidery pattern is created.
c
"Adding jump stitch trimming to new patterns" on page 275
Stitching
a
Note:
These settings are applied only when embroidering with our multi-needle embroidery machines. These
settings are not applied with any other embroidery machine.
270
Jump stitch Stitching