Brother PE-Design Next Instruction Manual page 167

Notes on embroidering using the multi-
position hoop
• Before embroidering your design, sew a
trial sample of the design on a scrap piece
of fabric from your design, making sure to
use the same needle and thread.
• Be sure to affix stabilizer material to the
back of the fabric and tightly stretch the
fabric within the hoop. When embroidering
on thin or stretch fabrics, use two layers of
stabilizer material. If no stabilizer material is
used, the fabric may become over-
stretched or wrinkled or the embroidery
may not be sewn correctly.
c
For more ways to stabilize large designs,
refer to "Attaching stabilizer to the fabric"
on page 156
• Use the zigzag stitch for sewing the
outlines in order to prevent embroidering
outside the outlines.
• For patterns that require the hoop to be
installed at different installation positions,
design the embroidery pattern so that the
various parts of the pattern overlap in order
to prevent misalignment while
embroidering.
Tutorial 10-2: Creating Design for Multi-Position Hoops
Overlap
■
Printing a Design Page for a multi-
position hoop
On the first page, a complete image of the Design
Page is printed at actual size. (However, for a 130 ×
300 mm Design Page, a reduced image of the
Design Page is printed.) On the following pages, an
image of each design section and its sewing
information are printed in the sewing order.
When Actual Size is selected:
An image of the pattern in each design section is
printed on a separate page as the corresponding
sewing information.
When Reduced Size is selected:
An image of the pattern in each design section is
printed on the same page as the corresponding
sewing information.
c
"Printing" on page 82
165