Brother PE-Design Next Instruction Manual page 67

■
Optimizing the entry/exit points
The entry and exit points for the stitching of
connected objects with the same color are
optimized (in other words, they are connected by the
shortest distance possible).
Optimize Entry/Exit points not selected
Optimize Entry/Exit points selected
Click 1, then 2, then 3.
1
2
3
 A check mark appears. beside Optimize
Entry/Exit points.
a
Note:
• Only entry and exit points for patterns
created with the Circle or Arc, Rectangle
and Line/Region tools can be optimized.
• If Optimize Entry/Exit points is applied,
all manual adjustments of the entry and
exit points will be lost.
Reshaping Embroidery Patterns
b
Memo:
To cancel optimizing, select this command so
that no check mark appears beside Optimize
Entry/Exit points.

If the optimizing of the entry and exit
points is cancelled, the entry point
and exit point positions are retained.
■
Moving the center point
The center point for regions set to the concentric
circle or radial stitch can be repositioned for a more
decorative effect.
1.
Click 1, then 2, then 3 to select the Entry/Exit/
Center Point tool.
1
2
3
2.
Click the region set to the concentric circle or
radial stitch.
3.
Drag the center point to the desired location.
Center point
65