Brother PE-Design Next Instruction Manual page 180

Using the Link Function to Embroider From the Computer
4.
Click 1, then 2, then 3.
1
3
(1)
(2)
(1) Transferred design
(2) Queue: Displays the data before it is
transferred to the embroidery machine.
 When the machine is ready to start
loading the data, data transfer begins.
While the data is being transferred, a
message appears in the screen of the
embroidery machine, and the design
moves to the transferred design area.
a
Note:
If the data sent from Layout & Editing does
not appear in the transferred design box,
continue the operation by using the
machine's operation panel.
b
Memo:
If you want to send more than one design to
the Link dialog, repeat step 4 for each design.
The Link dialog will remain open while the
selected design from Layout & Editing will be
sent to the Link.
178
5.
After the design has been transferred, press
the start/stop button on the embroidery
2
machine to begin embroidering.
b
Memo:
The transferred data cannot be edited from
the embroidery machine. The received data
can only be embroidered. However,
embroidering settings can be specified.
When embroidering is started, the following appears
in the Link dialog box.
(1)
(1) Shows the status of the embroidery
machine.
Each status indication is described below
Status
Ready
Waiting
Sewing
Paused
Color change
Check thread
Check frame
Error
Description
Press the button on the
embroidery machine (Start/
Stop button) to start sewing.
If there is no data in the queue
(2), select Link as the
destination in the application,
and send data.
If this is the status even though
there is data in the queue (2),
continue the operation by using
the machine's operation panel.
The machine is sewing.
The machine has temporarily
been stopped.
Change the thread spool on the
machine.
Check the bobbin thread or the
upper thread on the machine.
Install a different embroidery
frame on the machine.
Check the details of the error
that occurred on the machine.