Stitch Pattern - Brother PE-Design Next Instruction Manual

3
Click 1, and then click the second and fifth
wave regions.
1
 This region appears in blue and will be
sewn with no dropped stitches to give the
effect of embossing.
b
Memo:
To remove the embossing/engraving effect,
use the Region (reset) tool. Click 1, then 2,
and then click a region with an effect applied.
1
2
Step 4 Saving the edited fill/stamp

stitch pattern

Fill/stamp stitch patterns are saved in the .pas
format.
1
Click 1, then 2.
1
2
Creating Fill/Stamp Stitch Pattern
2
Select the drive and the folder, and then type
in the file name.
When saving a fill/stamp pattern, specify the
size beside Default Size. Click mm or inch to
select the measurement units.
3
Click Save.
Step 5 Using the edited fill/stamp stitch
patterns in Layout & Editing
1
Start up Layout & Editing.
2
Select an embroidery pattern.
3
From the Region sew type selector (in the
Attributes tab), select Prog. Fill Stitch.
4
Display the Sewing Attributes tab.
c
"Specifying sewing attributes" on page 58
5
Click below Programmable fill in the
Region sew section.
233