Rj21X Wiring Field Tools - AT&T MERLIN LEGEND Release 3.1 Installation Manual

Wiring
Spudger
Figure 4–3. RJ21X Wiring Field Tools
To connect the RJ21X network interface to the control unit, follow the steps
below. Figure 4–3 shows the tools you need.
1 For each piece of hardware, drill two diagonally opposite holes into the
backboard, allowing for a 1/16-inch (1.6 mm) space between each piece
of hardware.
2 Mount the wire troughs and the termination blocks.
There is a wire trough above and below each termination block.
AT-8762 D
Impact Tool
110 Impact Tool
788J1
Connecting the Control Unit to the Network Interface
788 K1 Retainer
Tool
Modular Plug Pressers
4–7