Initializing And Testing The System - AT&T MERLIN LEGEND Release 3.1 Installation Manual

Initializing and Testing
the System
When you have finished installation, you are ready to initialize the system as
described in this chapter.
Initializing the System
To initialize a Release 4.0 system, use one of the following methods:
Restore from a 4.0 system programming disk or Translation memory
card.
Upgrade to Release 4.0 from Release 1.0, 1.1, 2.0, 2.1, 3.0, or 3.1. See
Chapter 9, "Upgrading the System."
Use system programming forms and the procedures from one of the
guides listed in the next section, "Programming Guides."
This section describes how to restore the system from the Translation memory
card or the system programming disk.
NOTE:
On initial installations, make sure you perform a System Erase (frigid start), as
described in Maintenance and Troubleshooting , immediately before you
restore from a disk or memory card or before you program the system. Failure
to perform the System Erase (frigid start) can result in incorrect programming.

Initializing and Testing the System

7
7–1