Ed-1E434, Group 300 Cross-Connect Field Cabling; Central Location (Phase 1); Figure 58. Central Alarm And Maap Connections (Phase 1) - AT&T System 85 Installation And Test

ED-1E434, Group 300 Cross -Connect Field Cabling
Central Location (Phase 1)
Connect the ED -1E434, Group 300 cables from DO on the module control cabinet(s), that is
associated with a remote module, through the ductwork to the cross -connect field. Make
standard cross -connect field connections from the common control cabinet to the module
control cabinet(s) as shown in Figure 58. These cross-connections should be made in the
yellow wall field to each central module control associated with a remote module.
PROVIDED DURING INITIAL
SWITCH INSTALLATION
COMMON CONTROL
CABINET
JIT32 , 7<
—t<
(LOCATED
01
BELOW FAN
ASSEMBLY
LEVEL)
ED-1E434
GROUP 300
-48PX
GRD -48
ENS MT
ED-1E434
GROUP 300
. SEE TABLE CC FOR UNIT TYPE CONNECTIONS.
ED -1E434
GROUP 300
YELLOW FIELD
t .
ED-1E434
GROUP 340
'MULTIPLE TO EACH
MODULE CONTROL
CABINET WITH RMI
16
17
18
41
42
43
29
32
7
15
40
MODULE CONTROL
CABINET WITH
REMOTE MODULE
MODULE CONTROL
CARRIER 0
(LOCATED
AT MODULE
CONTROL
REM
CARRIER
DO
LEVEL)
>IALM10A
> 41 . _M108
ALM11
> , 1 1 :
13 0:
>422I
>41 2 1- 1 u
f -48
ACAL
>1 --
>I-48 PA
-48
il
.
r--
ENSMT
MC-1 CARRIER
DO
NOTE, FOR DUPLICATED SYSTEMS, AN ED-1E434 GROUP 340 CABLE IS USED TO "Y' MCO AND MC1 "DO"
CONNECTORS TOGETHER, AND THEN CONNECTS TO THE GROUP CABLE.
Figure 5 8 . Central Alarm and MAAP Connections (Phase 1)
Page 90