System Forms - AT&T MERLIN LEGEND Release 3.1 Installation Manual

System Forms

5. Connect the control unit to the network interface (required).
6. Connect the channel service unit (CSU) to the 100D module on the
control unit (required only with the 100D module).
7. Connect the printer and PC to the control unit (optional).
8. Connect data equipment to the control unit (optional).
9. Initialize and test the system (required).
10. Install the control unit housing (required).
11. Install applications (optional).
A list of required tools and equipment is given before each installation
procedure.
System Forms
Some of the installation procedures in this guide refer to system forms. These
forms indicate information that is specific to your customer's system. The
forms you need should be included with the system programming disk or
memory card, which contains all of the programming specifically for your
customer's system.
If you are upgrading an existing system and do not have the required forms
for your customer's system, you can load System Programming and
Maintenance (SPM) and print out the required forms.
If you find that you do not have a completed set of system forms for your
customer's system, contact your technical support organization or the
Customer Service Center (CSC). See the inside front cover for telephone
numbers.
The system forms that you need are specific for each system, and include
some or all of those described in the following sections.
1–2
Introduction