Disconnect Signaling Reliability - AT&T MERLIN LEGEND Release 3.0 Programming Summary Manual

Disconnect Signaling Reliability

Disconnect Signaling Reliability
Use this procedure to classify the disconnect signal sent by the central office
on loop-start trunks as one of the following:
Reliable. Signal sent within a short time.
Unreliable. Signal may not be provided.
The setting selected applies to all trunks in the system because trunks cannot
be programmed individually. The reliable/unreliable setting does not apply to
loop-start trunks emulated on a T1 facility. If you specify a reliable disconnect
for trunks programmed with a short hold disconnect interval (see "Hold
Disconnect Interval"), active calls as well as trunks on hold maybe
disconnected. For more information about reliable and unreliable disconnect
and its implications, see the Feature Reference.
NOTE:
Certain features (Remote Call Forwarding and Transfer to outside numbers)
and applications (CMS, AUDIX Voice Power, and MERLIN MAIL
recommended with loop-start trunks. See "Hold Disconnect Interval."
Summary: Disconnect Signaling Reliability
Programmable by
Mode
Idle Condition
Planning Form
Factory Setting
Valid Entries
Inspect
Copy Option
Console Procedure
PC Procedure
System manager, Integrated Administration
All
Not required
Form 2c, System Numbering: Line/Trunk Jacks
Unreliable
Unreliable, Reliable
No
No
LinesTrunks TT/LS Disc
Enter Exit
[F4] [F3] [F2] [F1] or [F2]
LS Disconnect
Exit
[F10]
Lines and Trunks 5-7
®
) are not
Yes or No
[F5] [F5]