Network Service - AT&T MERLIN LEGEND Release 3.0 Programming Summary Manual

Network Service

Network Service
Use this procedure to specify the type of outgoing service provided by each
B-channel group (Megacom WATS and 800, MultiQuest® Service, ACCUNET®
Switched Digital Service (SDS), or Software Defined Network (SDN).
NOTE:
You can enter a service not shown on the Network Service screen by using
the five-digit binary code that represents the service in the Network Facilities
Information Element of ISDN PRI signaling protocol. For information on these
codes, contact your service provider. See "Miscellaneous Procedure."
Summary: Network Service
Programmable by
Mode
Idle Condition
Planning Form
Factory Setting
Valid Entries
Inspect
Copy Option
Console Procedure
PC Procedure
9-6 PRI Facilities
System manager
Hybrid/PBX, Key
Not required
Form 3b, Incoming Trunks: DS1 Connectivity
(100D module)
Not applicable
AT&T Toll, Local, Miscellaneous
No
No
LinesTrunks PRI
group no.
Enter
Exit Exit Exit
[F4] [F6] [F2]
network service [F10]
B-ChannlGrp
Specify network service
Exit
[F3] Type group no.
[F5] [F5] [F5]
Dial
NetworkServ
Enter
[F10] Specify
[F5]