Group Calling Member Assignments - AT&T MERLIN LEGEND Release 3.0 Programming Summary Manual

Group Calling Member Assignments

Group Calling Member
Assignments
Use this procedure to assign or remove an extension from a calling group. A
calling group is used to direct calls to a group of people who all handle the
same type of call. A single extension number is assigned to the group and is
used by both inside and outside callers to reach the group.
To reassign an extension to a new calling group, you must remove it from its
old group before programming the new assignment.
NOTES:
1. If a linear hunting pattern is indicated on the back of the system
planning form (6d), be sure to assign extensions to the group in the
exact order that they are shown on the form. The system searches for
an available member in the order in which you assign the extensions to
the group.
2. A maximum of 32 calling groups with a maximum of 20 extensions per
group is allowed.
3. An extension can belong to only one calling group. A QCC cannot be
a member of a calling group. The delay announcement device should
not be programmed as a calling group member.
4.
The extension status feature must be set to the Calling Group or CMS
mode before you assign members to the group. See "Extension
Status."
Optional Group-Assigned Features 14-7