Installing The Cms Expansion Card; Disconnect The Power; Remove The Cover From The Pc - AT&T Merlin II Feature Module 2 Installation Ans Getting Started Manual

Installing the CMS Expansion Card

DISCONNECT
THE POWER
REMOVE THE COVER
FROM THE PC
12 Step 3: Installing Your Hardware
Use the following procedure for installing the CMS expansion card into your
PC. A flat-blade screwdriver is the only tool you need.
Turn the PC power switch to OFF and disconnect the PC power plug from
1
the power source.
Turn the printer power switch to OFF and disconnect its power plug from
2
the power source.
Turn the power switches to any other peripheral equipment to
3
disconnect their power plugs from the power source.
Failure to disconnect the power may damage the computer or
WARNING:
result in electrical shock.
Locate the two screws on the upper back comers of the unit (Figure 1).
1
Using a flat-blade screwdriver, unscrew each screw about 1/4 inch, or until
they move freely.
FIGURE 1 Loosening the screws on the PC.
Screws
and
OFF