Pool Routing - AT&T MERLIN LEGEND Release 3.0 Programming Summary Manual

Pool Routing

Pool Routing
Use this procedure to identify the trunk pools on which to route calls to area
codes and/or exchanges included in ARS tables.
A maximum of six routes (numbered 1 through 6) can be specified for each
subpattern. Pool routing is programmed for Tables 1 through 16. Tables 17
and 18, the Default Toll and Default Local tables respectively, cannot be
changed.
Summary: Pool Routing
Programmable by
Mode
Idle Condition
Planning Form
Factory Setting
Valid Entries
Inspect
Copy Option
Console Procedure
PC Procedure
System manager
Hybrid/PBX
Not required
Form 3f, Automatic Route Selection Tables
Form 3g, Automatic Route Selection Default and Special
Numbers Tables
Not applicable
Not applicable
No
No
Sub A Pools or Sub B Pool
Tables ARS
no. and pool route no.
Enter Exit Exit
[F8] [F6] [F3] or [F10]
no. [F10] Type pool dial-out code
Dial pool dial-out code
Enter
Type table no. and pool route
[F10]
Automatic Route Selection 16-7
Dial table
[F5] [F5]