AT&T MERLIN LEGEND Release 3.0 Programming Summary Manual page 35

Programming Information
Programming Basics
To begin programming, do the following:
On the console
On the PC
In most cases, to exit from a screen without making any changes, press Exit
or [F5]. Exceptions are noted as part of a procedure.
Ordinarily you complete a procedure by pressing Enter ( [F10] ) to save the
information you have programmed. Occasionally you press Exit ( [F5] ) and
go back to the previous screen.
If you are programming sequentially numbered extensions or trunks, you may
have the option of pressing Next ( [F8] ) to save your entry and automatically
provide the number of the next extension or trunk in the sequence, thus
saving you a couple of steps.
When you have completed a procedure, pressing Exit ( [F5] ) takes you up
one screen in the menu hierarchy.
In most cases, you will be at an intermediate step in the procedure you have
just completed. At that point, you can select one of the options shown on the
screen and continue programming, or you can press Exit again. This usually
takes you back to the system Programming menu. If not, you again have the
option of continuing to program from the current screen or pressing Exit
again.
In a few cases, pressing Exit brings you back to the System Programming
menu where you can select another option to program or exit from system
programming.
Select Menu
Sys Program
The System Programming menu is displayed.
Type SPM [Enter]
The System Programming menu is displayed.
Exit:
Press any key [F1]
Programming Basics 1-9
[F5]: