Remote Access Trunk Assignment - AT&T MERLIN LEGEND Release 3.0 Programming Summary Manual

Remote Access Trunk Assignment

When possible, block out-of-hours calling.
Frequently monitor system call detail reports for quicker detection of
any unauthorized or abnormal calling patterns.
Limit remote call forward to persons on a need-to-have basis.
Remote Access Trunk Assignment
Use this procedure to assign or remove the trunks used for remote access.
You can also use this procedure to specify whether the Remote Access
feature is dedicated (always used for remote access) or shared (used for
remote access only when Night Service is activated).
Trunks used for dedicated remote access must not be assigned to ring into a
calling group or the QCC queue (Hybrid/PBX mode only).
In Hybrid/PBX mode, if a trunk assigned to ring into the QCC queue is also
used for shared remote access, perform the procedure below before you
perform the "QCC Operator to Receive Calls" procedure.
NOTE:
A loop start trunk must be programmed for Reliable Disconnect if it is to be
used for remote access (see "Disconnect Signaling Reliability").
15-30 System Features