Manual Signaling - AT&T Merlin II Feature Module 2 System Manual

HOW TO USE

Manual Signaling

DESCRIPTION
CONSIDERATIONS
PROGRAMMING
2-106 MERLIN II System Features
5 Touch Message and go on to another procedure, or leave administration
mode.
Next, you assign the Loudspeaker Page feature to a line button at individual
consoles or voice terminals. Label the button(s) and follow the procedure for
assigning lines in a square, behind-switch, or pooled system. (See the "Line
Assignments" entry for your system type.)
If the system administrator has assigned your voice terminal a Loudspeaker
Page button, you can use the feature to page people or to make
announcements.
1 Touch Loudspeaker Page.
2 If you have a multizoned paging system, wait for the dial tone, then dial
the number for the page zone you want. (These zone numbers are a
function of the paging system, not the MERLIN II system.)
3 Lift your handset and make your announcement.
4 Hang up.
The loudspeaker turns off automatically.
You can use a Manual Signaling button to generate a beep at a co-worker's
voice terminal. Program a Manual Signaling button for each person you want
to signal.
You can signal
someone with a Manual Signaling button while you have
an outside call in progress.
The beep sounds at your co-worker's voice terminal even if it is busy.
If you program this feature on a button with lights, the green light next to
the button goes on when your co-worker
uses the Do Not Disturb feature.
You cannot have both a Manual Signaling
button for the same person. If you try to
the feature that you programmed earlier.
To program a Manual Signaling button, label
these steps:
1 Enter programming mode.
2 Touch the button you want to program.
3 Dial *60 plus the intercom number of the
4 Leave programming mode.
uses his or her voice terminal or
button and an Auto Intercom
program both, you deactivate
an available button and follow
person you are signaling.