Block Assignment - AT&T MERLIN LEGEND Release 3.0 Programming Summary Manual

Block Assignment

Block Assignment
Use this procedure to assign each DID trunk connected to the system to
either Block 1 or Block 2.
Summary: Block Assignment
Programmable by
Mode
Idle Condition
Planning Form
Factory Setting
Valid Entries
Inspect
Copy Option
Console Procedure
PC Procedure
8-2 DID Trunks
System manager
Hybrid/PBX
Not required
Form 3d, Incoming Trunks: DID
Block 1
Block 1, Block 2
Yes
Yes
To program a single line/trunk:
LinesTrunks DID
Enter Entry Mode
or Delete
Exit
To program a block of lines/trunks:
LinesTrunks DID
Select trunk lines
Enter
Exit Exit Exit
To program a single line/trunk:
[F4] [F4] [F1]
the line/trunk no.
To program a block of lines/trunks:
[F4] [F4] [F1]
trunk lines Toggle letter G On/Off
[F5] [F5]
Dial trunk block no.
Block
Type the line/trunk no.
Exit Exit
Dial trunk block no.
Block
Toggle LED On/Off
Type trunk block no.
[F10] or [F8] [F5]
Type trunk block no.
Enter
Enter
[F10] Type
[F5] [F5]
[F10] Select
[F10] [F5]