Memory Card Restore Error Messages - AT&T MERLIN LEGEND Release 3.0 Programming Summary Manual

Restore
Table 22-3. Memory Card Restore Error Messages
Message
RESTORE IS CANCELED
System is DOWN.
Inserted Memory Card is
not the correct type.
Board Mismatch between
control unit and file.
Restore File Mode is
Hybrid/PBX. Control Unit
strap in place for KEY.
Restore Failure
Try a different file or
a new Memory Card.
File is not compatible
for Release X.Y
Change Sys Programming
Port to Extension xxxx
before Restoring.
Verify that the Memory
Card has been inserted
correctly.
What it Means
Wait for the System Erase to complete and repeat
the restore procedure with a different
card or file.
Repeat the restore procedure with the correct
type of card.
Repeat the restore procedure with another file.
OR
Modify the system hardware to match the
configuration of the backup file and repeat the
restore procedure with the same file.
If the processor has been set for Permanent Key
mode a restore to Hybrid/PBX is not possible. A
qualified service associate should modify the
processor and repeat the restore procedure.
Repeat the restore procedure with a different file
and/or memory card.
Repeat the restore procedure with a compatible
file.
Use the Inspect feature to view the system
programming port specified in the backup file.
Change the system programming port to match
the port shown for the backup file and repeat the
restore procedure.
Verify that the card is inserted correctly and
repeat the procedure.
Memory Card 22-15