Pc Port Output; Restore - AT&T MERLIN LEGEND Release 3.0 System Programming And Maintenance Manual

Using SPM
Port
PC output
See "Printing Reports" for more information about the print procedure using
SPM and the PC port.

Restore

The Restore option allows qualified service personnel to load system
programming from a diskette or from the hard disk into the processor module
memory.
This procedure is used to program a new system if a disk was created
through surrogate mode programming, or to restore information (using a
backup disk) lost through system failure. It is also part of the upgrade
procedure.
NOTE:
With Release 3.0 and later, system programming can be backed up or
restored from a PCMCIA memory card. See Chapter 22, "Memory Card, "
more information.
Considerations
Review the following items before you begin the restore procedure.
The system will be forced idle during a restore procedure.
You must have a backup file containing system programming before
you use this procedure, See "Backup."
Features that were not programmed when the backup file was created
are reset to factory defaults.
The data restored reflects the number of extensions and lines available
on the system at the time the backup was created. The remaining
extensions and lines will be set to the default values that are initialized
during a Restart (cold start).
52 System Programming and Maintenance (SPM)
for