Setup Wizard Step 3 Of 10: System Date And Time - NETGEAR UTM9S Reference Manual

ProSecure Unified Threat Management (UTM) Appliance
Table 5. Setup Wizard Step 2: WAN Settings screen settings (continued)
Setting Description
Use Static IP Address If your ISP has assigned you a fixed (static or permanent) IP address, select the Use
Static IP Address radio button and enter the following settings.
IP Address
Subnet Mask
Gateway IP Address
Domain Name Server (DNS) Servers
Get Automatically from If your ISP has not assigned any Domain Name Servers (DNS) addresses, select the
ISP Get Automatically from ISP radio button.
Use These DNS If your ISP has assigned DNS addresses to you, select the Use these DNS Servers
Servers radio button. Make sure that you fill in valid DNS server IP addresses in the fields.
Incorrect DNS entries might cause connectivity issues.
Primary DNS Server
Secondary DNS Serve
After you have completed the steps in the Setup Wizard, you can make changes to the WAN
settings by selecting Network Config > WAN Settings. Then click the Edit button in the
Action column of the WAN interface for which you want to change the settings.
For more information about these WAN settings, see
Connection on page 71.

Setup Wizard Step 3 of 10: System Date and Time

Figure 27.
Using the Setup Wizard to Provision the UTM in Your Network
The static IP address assigned to you. This address identifies
the UTM to your ISP.
The subnet mask, which is usually provided by your ISP.
The IP address of the ISP's gateway, which is usually
provided by your ISP.
The IP address of the primary DNS server.
The IP address of the secondary DNS server.
Manually Configure the Internet
49