Led Descriptions, Utm5, Utm10, Utm25, Utm50, And Utm150 - NETGEAR UTM9S Reference Manual

ProSecure Unified Threat Management (UTM) Appliance
Figure 8. UTM9SWLSN wireless module
LED Descriptions, UTM5, UTM10, UTM25, UTM50, and
UTM150
The following table describes the function of each LED.
Table 2. LED descriptions UTM5, UTM10, UTM25, UTM50, and UTM150
LED Activity
Power LED On (green)
Off
Test LED On (amber) during
startup
On (amber) during
any other time
Blinking (amber)
Off
Description
Power is supplied to the UTM.
Power is not supplied to the UTM.
Test mode. The UTM is initializing. After approximately 2 minutes, when the
UTM has completed its initialization, the Test LED goes off.
The initialization has failed, or a hardware failure has occurred.
The UTM is writing to flash memory (during upgrading or resetting to
defaults).
The UTM has booted successfully.
Introduction
27