Setup Wizard Step 8 Of 10: Email Notification - NETGEAR UTM9S Reference Manual

ProSecure Unified Threat Management (UTM) Appliance

Setup Wizard Step 8 of 10: Email Notification

Figure 32.
Enter the settings as explained in the following table, and then click Next to go the following
screen.
Table 11. Setup Wizard Step 8: Email Notification screen settings
Setting
Administrator Email Notification Settings
Show as mail sender
SMTP server
This server requires
authentication
Send notifications to
After you have completed the steps in the Setup Wizard, you can make changes to the
administrator email notification settings by selecting Network Config > Email Notification.
For more information about these settings, see
page 422.
Using the Setup Wizard to Provision the UTM in Your Network
Description
A descriptive name of the sender for email identification purposes. For example,
enter UTM_Notifications@netgear.com.
The IP address and port number or Internet name and port number of your ISP's
outgoing email SMTP server. The default port number is 25.
Note: If you leave this field blank, the UTM cannot send email notifications.
If the SMTP server requires authentication, select the This server requires
authentication check box, and enter the user name and password.
User name The user name for SMTP server authentication.
Password The password for SMTP server authentication.
The email address to which the notifications should be sent. Typically, this is the
email address of the administrator.
59
Configure the Email Notification Server on