Firewall Restart; Ipsec Restart; Wan Status - NETGEAR UTM9S Reference Manual

ProSecure Unified Threat Management (UTM) Appliance

Firewall Restart

This section describes logs that are generated when the firewall restarts.
Table 155. System logs: firewall restart
Message
Explanation
Recommended Action

IPSec Restart

This section describes logs that are generated when IPSec restarts.
Table 156. System logs: IPSec restart
Message
Explanation
Recommended Action

WAN Status

This section describes the logs that are generated by the WAN component. If there are two
ISP links for Internet connectivity, the router can be configured either in auto-rollover mode or
load balancing mode.
Auto-Rollover Mode
When the WAN mode is configured for auto-rollover, the primary link is active and the
secondary link acts only as a backup. When the primary link goes down, the secondary link
becomes active only until the primary link comes back up.
The UTM monitors the status of the primary link using the configured WAN failure detection
method.
Jan 23 16:20:44 [UTM] [wand] [FW] Firewall Restarted
Logs that are generated when the firewall is restarted.
This message is logged when the VPN firewall restarts after any changes in the
configuration are applied.
None.
Jan 23 16:20:44 [UTM] [wand] [IPSEC] IPSEC Restarted
Logs that are generated when the IPsec is restarted.
This message is logged when IPsec restarts after any changes in the configuration
are applied.
None.
System Logs and Error Messages
585