Extensive Protocol Support; Easy Installation And Management - NETGEAR UTM9S Reference Manual

ProSecure Unified Threat Management (UTM) Appliance
Ethernet network. The four LAN and one or two WAN interfaces are autosensing and capable
of full-duplex or half-duplex operation.
The UTM incorporates Auto Uplink
whether the Ethernet cable plugged into the port should have a normal connection such as to
a PC or an uplink connection such as to a switch or hub. That port then configures itself
correctly. This feature eliminates the need for you to think about crossover cables, as Auto
Uplink accommodates either type of cable to make the right connection.

Extensive Protocol Support

The UTM supports the Transmission Control Protocol/Internet Protocol (TCP/IP) and Routing
Information Protocol (RIP). For further information about TCP/IP, see
Requirements on page 558. The UTM provides the following protocol support:
• IP address sharing by NAT. The UTM allows many networked PCs to share an Internet
account using only a single IP address, which might be statically or dynamically assigned
by your Internet service provider (ISP). This technique, known as Network Address
Translation (NAT), allows the use of an inexpensive single-user ISP account.
• Automatic configuration of attached PCs by DHCP. The UTM dynamically assigns
network configuration information, including IP, gateway, and Domain Name Server
(DNS) addresses, to attached PCs on the LAN using the Dynamic Host Configuration
Protocol (DHCP). This feature greatly simplifies configuration of PCs on your local
network.
• DNS proxy. When DHCP is enabled and no DNS addresses are specified, the firewall
provides its own address as a DNS server to the attached PCs. The firewall obtains
actual DNS addresses from the ISP during connection setup and forwards DNS requests
from the LAN.
• PPP over Ethernet (PPPoE). PPPoE is a protocol for connecting remote hosts to the
Internet over a DSL connection by simulating a dial-up connection.
• Quality of Service (QoS). The UTM supports QoS, including traffic prioritization and
traffic classification with Type of Service (ToS) and Differentiated Services Code Point
(DSCP) marking.

Easy Installation and Management

You can install, configure, and operate the UTM within minutes after connecting it to the
network. The following features simplify installation and management tasks:
• Browser-based management. Browser-based configuration allows you to easily
configure the UTM from almost any type of operating system, such as Windows,
Macintosh, or Linux. A user-friendly Setup Wizard is provided, and online help
documentation is built into the browser-based web management interface.
• Autodetection of ISP. The UTM automatically senses the type of Internet connection,
asking you only for the information required for your type of ISP account.
technology. Each Ethernet port automatically senses
TM
Introduction
18
Internet Configuration