Manage The Configuration File - NETGEAR UTM9S Reference Manual

ProSecure Unified Threat Management (UTM) Appliance
Table 99. SNMP screen settings (continued)
Setting
Enable Access From
WAN
Trusted SNMP Hosts
Enter the IP addresses of the computers and devices to which you want to grant read-only (GET) or write
(SET) privileges on the UTM. Separate IP addresses by a comma. To allow any trusted SNMP host access,
leave the field blank, which is the default setting.
SNMP Traps
Enter the IP addresses of the SNMP management stations that are allowed to receive the UTM's SNMP
traps. Separate IP addresses by a comma. If you leave the field blank, which is the default setting, no
SNMP management station can receive the UTM's SNMP traps.
3. Click Apply to save your settings.

Manage the Configuration File

The configuration settings of the UTM are stored in a configuration file on the UTM. This file
can be saved (backed up) to a PC, retrieved (restored) from the PC, or cleared to factory
default settings.
Once the UTM is installed and works correctly, make a backup of the configuration file to a
computer. If necessary, you can later restore the UTM settings from this file.
The Backup & Restore Settings screen lets you:
• Back up and save a copy of the current settings
• Restore saved settings from the backed-up file
• Revert to the factory default settings
To display the Backup & Restore Settings screen, select Administration > Backup &
Restore Settings.
Figure 243.
Description
Select the Enable Access From WAN check box to allow SNMP management
over a WAN connection. This check box is cleared by default, allowing SNMP
management only over a LAN connection.
Network and System Management
403