View The Active L2Tp Users - NETGEAR UTM9S Reference Manual

2. Enter the settings as explained in the following table:
Table 78. L2TP Server screen settings
Setting
L2TP Server
Enable L2TP Server
Authentication
Select one or more of the following authentication methods to authenticate L2TP users:
• PAP. RADIUS-Password Authentication Protocol (PAP).
• CHAP. RADIUS-Challenge Handshake Authentication Protocol (CHAP).
• MSCHAP. RADIUS-Microsoft CHAP (MSCHAP).
• MSCHAPv2. RADIUS-Microsoft CHAP version 2 (MSCHAPv2).
Note: For each authentication method that you want to use for L2TP users, you need to have created a
domain that supports the authentication method (see
L2TP users to the domain (see
3. Click Apply to save your settings.

View the Active L2TP Users


To view the active L2TP tunnel users:
Select Monitoring > Active Users & VPNs > L2TP Active Users. The L2TP Active Users
screen displays:
Figure 187.
ProSecure Unified Threat Management (UTM) Appliance
Description
To enable the L2TP server, select the Enable check box. Complete the following
fields:
Start IP Address
End IP Address
User time out
Configure User Accounts
Virtual Private Networking Using IPSec Connections
Type the first IP address of the address pool.
Type the last IP address of the address pool.
Enter the time-out period in seconds. If there is no traffic
from a user, the connection is disconnected after the
specified period.
Configure Domains on page 353) and have added the
on page 362).
304