Ssl Vpn Wizard Step 5 Of 6 (Port Forwarding) - NETGEAR UTM9S Reference Manual

ProSecure Unified Threat Management (UTM) Appliance
Table 83. SSL VPN Wizard Step 4 of 6 screen settings (client addresses and routes) (continued)
Setting
Primary DNS Server
Secondary DNS Server
Client Address Range Begin The first IP address of the IP address range that you want to assign to the VPN
Client Address Range End
Add Routes for VPN Tunnel Clients
Destination Network
Subnet Mask
After you have completed the steps in the SSL VPN Wizard, you can make changes to the
client IP address range and routes by selecting VPN > SSL VPN > SSL VPN Client. For
more information about client IP address range and routes settings, see
VPN Client on page 331.

SSL VPN Wizard Step 5 of 6 (Port Forwarding)

Figure 193.
Note that the previous figure contains an example. Enter the settings as explained in the
following table, and then click Next to go the following screen.
Virtual Private Networking Using SSL Connections
Description
The IP address of the primary DNS server that is assigned to the VPN tunnel
clients. This setting is optional.
Note: If you do not assign a DNS server, the DNS settings remain unchanged in
the VPN client after a VPN tunnel has been established.
The IP address of the secondary DNS server that is assigned to the VPN tunnel
clients. This setting is optional.
tunnel clients.
The last IP address of the IP address range that you want to assign to the VPN
tunnel clients.
Leave this field blank, or specify a destination network IP address of a local
network or subnet that has not yet been used.
Leave this field blank to specify the address of the appropriate subnet mask.
317
Configure the SSL