Pn firewall 200 with 8-port 10/100 and 1 gigabit lan and dual wan port switch (2 pages)
Summary of Contents for NETGEAR SRX5308 - ProSafe® Quad WAN Gigabit SSL VPN Firewall
Page 1
This document will guide you on how to create IKE and auto-VPN policies for your ProSafe NETGEAR Router, as well as how to configure the ProSafe VPN Lite Client in order to allow a Virtual Private Network to be established over the Internet.
Page 2 of 8 Router Settings: As we configure the NETGEAR VPN Router, there will be information we’ll add which will later be used in the configuration of the ProSafe VPN Lite Client. This information will be marked with red- numbered circles.
Page 3
Page 3 of 8 Creation of the VPN Policy on the ProSafe Router: From the Router’s GUI, go to the VPN section and then select the VPN wizard. Select the VPN Client option. The following fields will now be available: Connection Name: The name can be any alphanumeric string.
Page 4
Page 4 of 8 Once you apply, you will see the policy we created in the list of VPN Policies. Make note of the following: ➍ ➍ ➍ ➍ Router’s LAN Network IP Address: The first segment in the ➍ ➍ ➍ ➍ ➎...
Page 5
Configuration Panel. Select Config Wizard from the VPN Configuration option in the menu. Select “A router or a VPN gateway” to create a new policy to establish a Client-to-Box connection with a NETGEAR router or VPN gateway. Version 1.2...
Page 6
Page 6 of 8 ➏ ➏ ➏ ➏ The IP or DNS public address of the remote equipment will be the value of your Router’s WAN IP or FQDN. ➏ ➏ ➏ ➏ ➊ ➊ ➊ ➊ Input the PreShared Key used ➊...
Page 7
Page 7 of 8 A new policy should be added under Root. Verify the Remote Gateway to make sure that it is the remote Router’s WAN IP or FQDN. ➏ ➏ ➏ ➏ Click on the policy name, then select the P1 Advanced button. Check Aggressive Mode.
Page 8
Page 8 of 8 Connecting: To connect and establish the VPN tunnel between the VPN Lite Client and the remote router, click on Tunnel1, then Open Tunnel. If your settings are correct you’ll receive a message confirming the connection. Open Tunnel Connection Status Version 1.2...