Manage The Application Level Gateway For Sip Sessions - NETGEAR UTM9S Reference Manual

Table 31. Session Limit screen settings (continued)
Setting
User Limit
Total Number of
Packets Dropped due
to Session Limit
Session Timeout
TCP Timeout
UDP Timeout
ICMP Timeout
4. Click Apply to save your settings.

Manage the Application Level Gateway for SIP Sessions

The application level gateway (ALG) facilitates multimedia sessions such as voice over IP
(VoIP) sessions that use the Session Initiation Protocol (SIP) across the firewall and provides
support for multiple SIP clients. ALG support for SIP is disabled by default.

To enable ALG for SIP:
1. Select Network Security > Firewall > Advanced. The Advanced screen displays (see
the following figure).
2. Select the Enable SIP ALG check box.
3. Click Apply to save your settings.
Figure 84.
ProSecure Unified Threat Management (UTM) Appliance
Description
Enter a number to indicate the user limit.
If the User Limit Parameter is set to Percentage of Max Sessions, the number
specifies the maximum number of sessions that are allowed from a single-source
device as a percentage of the total session connection capacity of the UTM. (The
session limit is per-device based.)
If the User Limit Parameter is set to Number of Sessions, the number specifies an
absolute value.
Note: Some protocols such as FTP and RSTP create two sessions per connection,
which should be considered when configuring a session limit.
This is a nonconfigurable counter that displays the total number of dropped packets
when the session limit is reached.
For each protocol, specify a time-out in seconds. A session expires if no data for
the session is received for the duration of the time-out period. The default time-out
periods are 1200 seconds for TCP sessions, 180 seconds for UDP sessions, and
8 seconds for ICMP sessions.
Firewall Protection
151