Create Custom Groups For Web Access Exceptions - NETGEAR UTM9S Reference Manual

• Enable. Enables the rule or rules. The ! status icon changes from a gray circle to a
green circle, indicating that the rule is or rules are enabled.
• Delete. Deletes the rule or rules.
The table rank of the exception rule in the Exceptions table determines the order in which the
rule is applied (from the top down). To change the position of the rules in the table, select one
or more a rules, and then click one of the following table buttons:
• Up. Moves the rule or rules up one position in the table rank.
• Down. Moves the rule or rules down one position in the table rank.

Create Custom Groups for Web Access Exceptions

After you have specified groups and users (see
and Users on page 345), you can create up to 200 custom groups, each of which can include
a combination of local groups and local users, groups and users that are defined by their IP
addresses, LDAP groups and users, and RADIUS groups and users. You use these custom
groups to set web access exceptions on the Exceptions screen (see
Exception Rules on page 221).

To create and manage custom groups:
1. Select Application Security > Block/Accept Exceptions > Custom Groups. The
Custom Groups screen displays. This screen shows the Custom Groups table, which is
empty if you have not specified any custom groups. (The following figure shows one
custom group in the table as an example.)
Figure 127.
2. Under the Custom Groups table, click the Add table button to specify a custom group. The
Add Custom Group screen displays:
ProSecure Unified Threat Management (UTM) Appliance
Content Filtering and Optimizing Scans
Configure Authentication Domains, Groups,
228
Set Web Access