Table 24 Add Paper To Mbf, Tray 1, 2 Or 3 Message Troubleshooting Procedure; Rap 5; Rap 4 Load Mbf / Load Tray 1 / Load Tray 2 / Load Tray 3; Load Tray - Xerox 5400N - Phaser B/W Laser Printer Service Quick Reference Manual

RAP 4 Load MBF / Load Tray 1 / Load Tray 2 /

Load Tray 3

Logic Control on the Print Engine Controller Board detected a problem where a false
message to add paper to the MBF or a Paper Tray appears on the LCD.
Table 24 Add Paper to MBF, Tray 1, 2 or 3 Message Troubleshooting
Procedure
Step Actions and Questions
1 Does this problem appear only when using
Tray 2 or Tray 3?
TRAY 1 PAPER LEVEL
2
Inspect the paper level in Tray.
Are there at least 100 sheets of paper in Tray 1?
3 MBF PAPER LEVEL
Inspect the paper level in the MBF.
Is there paper in the MBF?
4 MBF TRAY TEST PRINT
1. Enter Diagnostics mode.
2. From the Main Menu, select Test Print / Input Tray /
MBF / press [4] to select MBF as Input Tray.
3. From the Main Menu, select Test Print / Print Pattern /
press [4] to generate a test print.
Does the Load MBF message appear when you
feed paper from the MBF?
TRAY 1 TEST PRINT
5
1. Enter Diagnostics mode.
2. From the Main Menu, select Test Print / Input Tray /
Tray 1 / press [4] to select Tray 1 as Input Tray.
3. From the Main Menu, select Test Print / Print Pattern /
press [4] to generate a test print.
Does the Load Tray 1 message appear when you
feed paper from Tray 1?
6 BOTTOM PLATE INSPECTION
1. Remove Tray 1 from the printer.
2. Remove the Tray Cover, if installed, and all paper from
the tray.
3. Insert Tray into the printer and inspect the Bottom
Plate.
Is the bottom plate raised fully and evenly?
48
Yes
Go to

RAP 5,

page
[500-Sheet
Feeder].
Go to
RAP 8,
page
[2000-Sheet
Feeder].
Go to
Step 3.
Go to
Step 4.
Go to
Step 9.
Go to
Step 6.
Go to
Step 7.
Phaser 5400 Laser Printer Service Guide
No
Go to
Step 2.
50,
58,
Load paper
into Tray 1.
Load paper
into the
MBF.
Go to
Step 5.
Return to
Service Flow
Chart.
Replace the
Tray 1
Assembly
[PL 2.1,
page 386;
PL 2.2,
page 388].