Figure 38 Top Cover Assembly; Rrp 1.3 Top Cover Assembly - Xerox 5400N - Phaser B/W Laser Printer Service Quick Reference Manual

RRP 1.3 Top Cover Assembly

(See PL 1.1 Covers)

Figure 38 Top Cover Assembly

Removal
Warning: Switch off the power and disconnect the Power Cord.
1. Open the Rear Cover.
2. Remove the HCS, if installed (RRP 10.1 1000-Sheet High Capacity
Stacker [HCS]).
3. Open the Top Cover and remove the Print Cartridge.
4. Cover the cartridge to protect it from light.
5. Remove the Left Side Cover (RRP 1.1 Left Side Cover).
Note: The top is secured by three types of screws. Note the type and
position of each of the screws as they are removed. This
information will be required for replacement of the screws.
6. Remove the eight screws that secure the Top Cover Assembly to the printer.
7. Remove the two screws that secure the Right and Left Print Cartridge Latches to
the Top Cover.
8. Disconnect P/J421 from the rear of the Control Panel.
9. Remove the Top Cover Assembly. A small flat blade screwdriver may be used to
release the two latches (one at each front) from the sides.
Replacement
Reinstall the components in the reverse order.
252 Phaser 5400 Laser Printer Service Guide