Work Notes - Xerox 5400N - Phaser B/W Laser Printer Service Quick Reference Manual

Introduction
This repair subsection contains instructions for removal and replacement tasks. A
removal and/or replacement task is included when it is not obvious how components
are removed and replaced, or when special conditions (such as an adjustment) must
be met during these tasks.
Step-by-step removal procedures for a specific component or assembly are provided.
Numbers in the illustrations refer to steps in the procedure. For example: if step 3 in a
procedure instructed you to remove a screw, the screw in the illustration would be
labeled 3.
Illustrations are used to assist you with the procedures. You should refer to the
specific Parts List illustration (listed under the repair title) for locating most
components within a procedure.
Cautions: Always reinstall the correct type and size screws. Using the
wrong screw can damage tapped holes.
Do not use excessive force to either remove or install a part.
Locations, such as left, right, front, or rear, given in the repairs assume you are facing
the printer Control Panel.

Work Notes

Note: Names of parts that appear in the RRPs may not be exactly
the same as the names appear in the Section 12 Parts List.
For example, a part called the Metal Registration Roller in
an RRP may appear on the Parts List as Registration Metal
Roller. When working on an RRP, ignore any prerequisite
RRP if you have already performed that removal procedure.
Caution: Always use the correct type and size screw. Using the
wrong screw can damage tapped holes. Do not use
excessive force to either remove or install either a screw or
a printer part.
Warning: Unplug the AC power cord from the AC wall outlet before
removing any printer part.
248 Phaser 5400 Laser Printer Service Guide