Scheduled Maintenance; Recommended Tools; Inspect While Servicing - Xerox 5400N - Phaser B/W Laser Printer Service Quick Reference Manual

Maintenance and Cleaning

Scheduled Maintenance

The Phaser 5400 Laser Printer is designed and tested to require little maintenance. A
User Maintenance Kit (P/N 109R00521 for 110 volt printers and 109R00522 for
220 volt printers) contains:
Replacement Fuser
I
Bias Transfer Roller
I
Cleaning Cloth
I
The printer will tell the user when to install the User Maintenance Kit
(200,000 prints). Normally, it is not necessary for a trained technician to install the
kit. Following installation, it is necessary to reset the maintenance counter.
Note: See NVRAM Adjustments in the Diagnostics, Test Prints,
Services Tests and NVRAM Adjustments section of this
manual for this procedure.

Recommended Tools

Standard service tools used in printer repair
I
Toner vacuum, such as the 3M Toner Vac
I
Caution: Do NOT use a standard vacuum to clean up a toner spill.
Suction bulb to use as an air puff blower
I
Toner rags (specially treated fibrous paper cleaning "rags" that attract and
I
pick up toner and dust particles
Cotton swabs (for those hard to get at places)
I
Cleaning cloth
I
Isopropyl alcohol
I
Simple Green or equivalent cleaner
I

Inspect While Servicing

The above represents all the scheduled maintenance for this printer; however, it is
important for all qualified service technicians to always inspect and clean
"on-the-fly" whenever repairing or otherwise servicing the printer.
Phaser 5400 Laser Printer Service Guide 241