Figure 98 Main Fan; Rrp 8.4 Main Fan - Xerox 5400N - Phaser B/W Laser Printer Service Quick Reference Manual

RRP 8.4 Main Fan

(See PL 9.1 Electrical (1 of

Figure 98 Main Fan

Removal
Caution: These components are susceptible to electrostatic
discharge. Observe all ESD procedures to avoid damage.
Warning: Switch off the power and disconnect the Power Cord.
1. Remove the Lower Rear Cover (RRP 1.7 Lower Rear Cover).
2. Remove the Rear Cover (RRP 1.9 Rear Cover).
3. Remove the HCS if installed (RRP 10.1 1000-Sheet High Capacity
Stacker [HCS]).
4. Remove the Left Side Cover (RRP 1.1 Left Side Cover).
5. Open the Top Cover and remove the Print Cartridge. Cover the cartridge to protect
it from light.
6. Remove the Top Cover Assembly (RRP 1.3 Top Cover Assembly).
7. Remove the screw that secures the left edge of the HVPS Cover.
8. Disconnect P/J165 from the LVPS PWB.
9. Remove the three screws that secure the Fan Guard to the printer.
10.Remove Fan Harness from all clamps.
11.Remove the screw that secures the Main Fan to the printer. Remove the fan.
Replacement
Reinstall the components in the reverse order.
Phaser 5400 Laser Printer Service Guide
2))
309